Description
ArcHaul Field is the rugged mobility model in the Encrypted Syntax Labs Fabricator Series. Its cabinet storage, accessory panel, twin-cylinder rack, and mixed running-gear layout are intended for fabricators who move between the shop floor and rougher yard surfaces.
WHAT YOU RECEIVE
- 17-page branded PDF fabrication plan book
- Cart-only STEP model
- Equipment fit-check STEP model
- 16 DXF flat-part files in inch units
- 16 DXF flat-part files in metric units
- 16 metric SVG flat-part files
- Two 28 in full-length slide-carrier rails and four formed end brackets
- Drawer-slide purchase guide with Rockler item number, Accuride drawing, and McMaster alternate
- Tube cut list and bill of materials in CSV format
- Read-me, verification notes, and limited physical-build license
DESIGN ENVELOPE
- Overall nominal envelope: 26 × 42 × 38 in
- Metric envelope: 660 × 1067 × 965 mm
- One top machine bay
- Twin rear cylinder bays
- Enclosed lower cabinet
- Vented access door
- Perforated accessory panel
- Two front-caster and two rear-wheel locations
PLUG-AND-PLAY DRAWER SYSTEM
The controlled reference is a 22 in Accuride 3832E full-extension side-mount slide pair (Rockler item 69973). The package includes slotted carrier rails, formed bolt-on end brackets, fit-stack dimensions, a direct manufacturer drawing, #8 fastener guidance, and a heavier McMaster-Carr alternate. Purchased slides and the recommended positive mobile-cart drawer latch are not included. Alternate slides must be measured and match-drilled because hole patterns and body heights vary.
FABRICATION WORKFLOW
Open the supplied DXF, SVG, or STEP files in compatible CAD/CAM software. Before cutting, confirm your machine envelope, both cylinder sizes, front-caster and rear-wheel mounting details, axle or hub selection, material thicknesses, and your shop process. Set kerf, lead-ins, amperage, feed rate, pierce delay, and post processor for your own machine.
IMPORTANT
The product photographs are rendered visualizations of the intended finished cart. Dimensioned plan values and supplied CAD files control the build. Generic equipment, cylinder, caster, and rear-wheel solids in the fit-check model are clearance references, not purchased-part models.
Builder is responsible for material selection, weld quality, stability, final fit, load verification, safe fabrication practices, and compliance with applicable requirements. This package is not engineering certification or a code-approved design.
Secure digital delivery
Purchase directly from Encrypted Syntax Labs for protected account-based downloads after successful payment. No physical item will be shipped.
Prefer Etsy? Purchase this product through our Etsy shop.
Reviews
There are no reviews yet.