Description
ArcHaul Tandem is the two-machine workhorse in the Encrypted Syntax Labs Fabricator Series. It gives a fabricator organized MIG/TIG or multiprocess capacity in one rolling station, with twin-cylinder storage and dedicated cut-ready files.
WHAT YOU RECEIVE
- 17-page branded PDF fabrication plan book
- Cart-only STEP model
- Equipment fit-check STEP model
- 13 DXF flat-part files in inch units
- 13 DXF flat-part files in metric units
- 13 metric SVG flat-part files
- Two 26 in full-length slide-carrier rails and four formed end brackets
- Drawer-slide purchase guide with Rockler item number, Accuride drawing, and McMaster alternate
- Tube cut list and bill of materials in CSV format
- Read-me, verification notes, and limited physical-build license
DESIGN ENVELOPE
- Overall nominal envelope: 24 × 40 × 40 in
- Metric envelope: 610 × 1016 × 1016 mm
- Upper and lower machine zones
- Twin rear cylinder bays
- Full-width front drawer
- Ventilated lower enclosure
- Side tool and cable management
- Four running-gear locations
PLUG-AND-PLAY DRAWER SYSTEM
The controlled reference is a 20 in Accuride 3832E full-extension side-mount slide pair (Rockler item 65669). The package includes slotted carrier rails, formed bolt-on end brackets, fit-stack dimensions, a direct manufacturer drawing, #8 fastener guidance, and a heavier McMaster-Carr alternate. Purchased slides and the recommended positive mobile-cart drawer latch are not included. Alternate slides must be measured and match-drilled because hole patterns and body heights vary.
FABRICATION WORKFLOW
Open the supplied DXF, SVG, or STEP files in compatible CAD/CAM software. Before cutting, confirm both equipment envelopes, both cylinder sizes, caster mounting patterns, material thicknesses, and your shop process. Set kerf, lead-ins, amperage, feed rate, pierce delay, and post processor for your own machine.
IMPORTANT
The product photographs are rendered visualizations of the intended finished cart. Dimensioned plan values and supplied CAD files control the build. Generic equipment, cylinder, and running-gear solids in the fit-check model are clearance references, not purchased-part models.
Builder is responsible for material selection, weld quality, stability, final fit, load verification, safe fabrication practices, and compliance with applicable requirements. This package is not engineering certification or a code-approved design.
Secure digital delivery
Purchase directly from Encrypted Syntax Labs for protected account-based downloads after successful payment. No physical item will be shipped.
Prefer Etsy? Purchase this product through our Etsy shop.
Reviews
There are no reviews yet.